Structural
Structural Machines
STOP! Wasting time Drilling!
Use the economical way and punch it!
Work Smarter and Faster, NOT Harder!
Fact: Punches and dies last Thousands of holes longer than drills and ALL the holes are clean!
Fact: It takes much MORE time to drill a hole, than it does to punch it.
Fact: A CNC Beamline or Anglematic is MUCH more accurate than a hand held drill
Can't move the steel that needs punched to the Machine?
�
A Portable Re-furbished "C"
Frame punch Is the Answer!
Yes, take the Machine to the steel
CNC Machines
Completely Re-furbished
For Angle punching. 
845D
Single and / or dual gage lines of punched holes.
Gauge line settings are manually pre-set on clear easily read scales located on each press.
The CNC part program selects upper or lower hole positions for each press.
The two different hole locations are obtained by the CNC controlling a pneumatic cylinder.
845F
Infinite gauge lines.
Gauge lines are controlled by the CNC via servo driven ballscrews.
There is no presetting required on the presses!
For Beam punching
Gauge line settings are manually pre-set on clear easily read scales located on each press.
The CNC part program selects upper or lower hole positions for each press.
The two different hole locations are obtained by the CNC controlling a pneumatic cylinder.
845F
Infinite gauge lines.
Gauge lines are controlled by the CNC via servo driven ballscrews.
There is no presetting required on the presses!
For Beam punching
Gauge line settings are manually pre-set on clear easily read scales located on each press.
The CNC part program selects upper or lower hole positions for each press.
The two different hole locations are obtained by the CNC controlling a pneumatic cylinder.
845F
Infinite gauge lines.
Gauge lines are controlled by the CNC via servo driven ballscrews.
There is no presetting required on the presses!
For Beam punching
Gauge line settings are manually pre-set on clear easily read scales located on each press.
The CNC part program selects upper or lower hole positions for each press.
The two different hole locations are obtained by the CNC controlling a pneumatic cylinder.
845F
Infinite gauge lines.
Gauge lines are controlled by the CNC via servo driven ballscrews.
There is no presetting required on the presses!
For Beam punching
The two different hole locations are obtained by the CNC controlling a pneumatic cylinder.
845F
Infinite gauge lines.
Gauge lines are controlled by the CNC via servo driven ballscrews.
There is no presetting required on the presses!
For Beam punching
845F
Infinite gauge lines.
Gauge lines are controlled by the CNC via servo driven ballscrews.
There is no presetting required on the presses!
For Beam punching
845F
Gauge lines are controlled by the CNC via servo driven ballscrews.